Tytan SAT DS540 GPS Tracker

Elements GPS Mapping Server Port: 11919

“Tytan DS540

Real-time tracking device with CAN-bus

GSM/GPRS device designed for real time tracking of vehicles and cargo or supervising technical objects. It is intended for passenger, construction, money transport and agricultural vehicles, buses, trucks, etc.
DS540 communicates with server via GSM network. Device transmits location data (GPS/GLONASS position and speed) with current parameters and events registered in monitored objects to external server using UDP or TCP protocol.
Due to analogue/digital inputs and interfaces (RS485, 1-wire) the device: a) measures data from 2 sensors with analogue output signal and from analogue/digital fuel level sensors, b) authorizes access to a vehicle via iButton identifiers, c) measures temperature via 1-wire sensors, d) monitors status of 2 switches. Due to digital outputs the device allows users to control 2 circuits remotely.
It reads data from CAN-bus of over 800 passenger cars: fuel level, engine RPM, door/trunk/bonnet status, OEM remote locking and unlocking of the vehicle, triggering vehicle OEM alarm etc.
DS540 reads from CAN/FMS/J1939/J1708 buses among others: fuel level, fuel consumption, engine RPM, engine load and temperature, tachograph data, door/trunk/bonnet status, OEM remote locking and unlocking of the vehicle, triggering vehicle OEM alarm.

TECHNICAL SPECIFICATION

Power supply 12V/24V (voltage range 8-40V).
Power consumption: average 14-36 mA (depending on configuration of transmission intervals).
Power saving modes: GPS sleep and deepsleep – min. power consumption 1.2mA.
2 analogue inputs, operation as analogue inputs 0-10V/0-30V and digital inputs.
2 digital outputs (OC type).
Readouts of data from CAN and J1708 buses concerning over 800 cars and trucks.
Built-in 3-axe accelerometer to detect drive condition without connecting ignition circuit.
RS485 interface for communication with digital fuel level sensors (Technoton, Eljunga, Omnicomm, Technokom).
1-wire interface: iButton identifiers (Dallas DS1990A) and DS18B20 digital temperature sensors.
List of up to 500 authorized iButton identifiers.
Immobiliser function.
Quad-band GSM/GPRS modem Simcomm SIM800C.
Built-in GPS/GLONASS receiver Tytan Digital Systems GPS/GLONASS 1537 with simultaneous observation of GPS and GLONASS satellites.
Built-in GSM/GPRS modem 850/900/1800/1900MHz with external GSM antenna.
Built-in GPS/GLONASS/GALILEO/QZSS receiver with external active GPS/GLONASS antenna.
NMEA 0183 v3.01 (GGA, GSA, GSV, RMC, VTG) protocol.
High sensitivity: 161dBm.
32-bit Microchip MX7 microcontroller, 512kB Flash ROM, 128kB RAM.
Built-in 4Mb memory to store data. Capacity: up to 50000 reports.
Remote configuration and firmware upgrades via GSM/GPRS using FTP protocol.
Two LEDs signalling device operation.
USB port for configuration and device diagnostics.” – Tytan

Categories: Supported Trackers